Sitecom WL-203 Manual de usuario descargar pdf (Pagina 49)

Please check www.sitecom.com for up to date drivers & utilities, manuals and support

11.3 Using the Init Button and the TFTP Client

• Plug in the power adaptor while pressing the Init button until the LED indicators of Power

and USB blink.

Note：

Please note that after that, the Server will operate using the factory default values after restarting,

i.e., your Server’s configuration will recover to Factory Default values.

• Start the TFTP client Tool: Image Burner

• Press Start -> All Programs -> Sitecom -> Multi-Function Printserver Control Center ->

Image Burner.

• Enter the Server’s Fallback IP address: 192.168.0.100 and click Open Image to open your

new firmware. Please note that you must configure your PC’s TCP/IP such that PC and the

Server belong to the same LAN, i.e. PC’s IP is 192.168.0.xxx and subnet mask is

255.255.255.0.

• Click Upload Image.

• Wait for Image Uploading to finish and then click Close.

• Plug-off the power adapter and then plug-in the power adapter to restart the Server.

12. The Init Button

The Init button is used for maintenance:

Simultaneously press the Init button and turn on (by plugging in the power adaptor) the Server

until the USB1 and USB2 LED indicators simultaneously blink. After that, the Server will do the

following tasks:

• Perform a Factory Default of the MFP server, which will restore most of the parameters and

settings to factory default values,

• Start a TFTP server. You can upgrade new firmware using any TFTP client tool.

1 2 ... 44 45 46 47 48 49 50

Sin comentarios

Sitecom WL-203 Manual de usuario Pagina 49